BDS Suspension 2014-18 GM 1500 upper control arm - Aluminum / Stamped Steel CA - BDS121152

2014-18 GM 1500 upper control arm - Aluminum - Stamped Steel CA

• High strength 1.5-inch tubular construction improves strength and durability over stock UCA
• Indexed ball joint cup allows for increased travel on leveled/lifted applications
• Factory style rubber bushings for long lasting maintenance-free operation
• High quality greaseable ball joints and a protective cap to keep out debris
• Fully assembled and ready to install right out of the box
• Designed for vehicles with OE stamped steel or aluminum control arms.
• Will NOT fit vehicles with OE cast steel arms (use #121151).
• Control arms are much larger than stock. Tire/wheel selection is critical to allow for proper clearance.
• Optional weld-on steering stops are for cast steel and stamped steel arms only to eliminate any possible contact between the tire and upper control arm (these steering stops cannot be used on aluminum arms).
• Wheels (stock/leveled) - 4.5 Backspacing required to run 12.50 wide tires. 5" backspacing will work with 11.50 wide tires (285)."
• Wheels (BDS 4.5/6.5) - works with wheels listed on kit fitment. May require the use of supplied weld-on steering stops for some combinations
• Will NOT fit Magneride equipped models.
• The included wheel spacer is to be used in the event the factory spare tire needs to be installed this is for temporary use only.
• Will work with most leveling kits and 6 lift kits on the market."