Borgeson Steering Shaft Support 6in. Billet Steel Weld On 3/4in. ID - 670600

If more than two joints are used in a steering system, a support bearing must be used to prevent "looping" and binding. Use of a vibration reducer and two u-joints will also call for a support bearing to be used. A system with a double u-joint and a single u-joint has three flex points and will require a support bearing. Support bearings will work with all 3/4 in. splined or Double D steering shafts. All billet supports accommodate a 3/4 in. shaft. Our standard supports are 2-1/2 in. tall with two 5/16 in.-18 threaded holes in the end for mounting and are available in steel, aluminum, polished aluminum, stainless steel, and polished stainless steel. The 6 in. cut and weld billet support is available only in steel and can be cut at any angle for a perfect fit.

Steering Shaft Support Bearing